Effect of iron on enamel demineralization and remineralization in vitro

Abstract

ObjectiveTo evaluate the effect of ferrous sulphate on enamel demineralization and remineralization, using pH-cycling models. DesignFifty blocks were selected by their initial surface hardness and subjected to a pH-cycling demineralization process. Artificially demineralized lesions were produced in 60 blocks; out of these blocks, the surface hardness of 50 blocks and the cross-sectional hardness of 10 blocks were determined. The 50 blocks were then subjected to a remineralization pH-cycling process. Treatments were carried out using ferrous sulphate solutions of different concentrations (0.333, 0.840, 18.0, and 70.0μg Fe/mL) and a control group (deionized water). The final surface hardness (SH2) was determined, and the integrated subsurface hardness (ΔKHN) was calculated. The enamel blocks were analysed for fluoride, calcium, phosphorus, and iron. The obtained data were distributed heterogeneously and were analysed using the Kruskal–Wallis test (p<0.05). ResultsIn demineralization pH cycling, the group treated with the 18.0μg Fe/mL solution had higher secondary surface hardness and lower integrated subsurface hardness (ΔKHN) than the other groups. In remineralization pH cycling, the control group showed the lowest value of ΔKHN. A decline in Ca and P concentration was observed when the Fe concentration increased (p<0.05). There was no significant difference in the F concentration (p>0.05) and an increase in Fe concentration (p<0.05) in the enamel was observed when the Fe concentration increased in both the demineralization and remineralization experiments. ConclusionThe results suggest that iron reduces demineralization but does not allow remineralization to occur.