Abstract
In this paper, the structural response of steel tubular wind turbine towers with various design configurations is analysed using FEM modelling. Towers of various heights between 50 and 250m are considered and investigated with three different design options as follows: (i) thick walled tower with internal horizontal stiffening rings, (ii) thick walled tower without stiffening rings and (iii) thin walled tower with stiffening rings. Based on this analysis, weight reduction ratios are examined in relation to the horizontal sway and von Mises stress increase ratios in order to identify a more efficient design approach between reducing the wall thickness and adopting internal stiffeners. All studied design solutions satisfy the strength and serviceability requirements as specified by the design codes of practice. In the final part of paper, the dynamic characteristics of these three types of towers have been examined to obtain the natural frequencies and mode shapes. The studied model ignored the mass of nacelle-rotor system and the wind turbines, namely, only the isolated tower was included. Furthermore, the recommendations to avoid resonance for each height case are proposed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
