Abstract
Annealing is an effective strategy to improve the properties of high-strength twin-induced plasticity (TWIP) steels, however, the adaption of intermediate annealing during cold rolling (CR) is scarcely studied. Here, the Fe-19Mn-0.6C TWIP steel was subjected to CR-annealing and CR-intermediate annealing-CR-annealing processes at room temperature to determine the role of intermediate annealing in the improvement of microstructure and mechanical properties. The total cold-rolled reduction in both processes is 75%. The morphological and phase characterizations of the TWIP steel annealed for 1 h showed that uneven element distribution had occurred as the annealing temperature was greater than the recrystallization start temperature, causing the presence of minor carbides. Moreover, the carbides vanished at the recrystallization end temperature and were quantitatively analyzed content via the refined XRD. Finally, the recrystallized austenite grains completely replaced the cold-deformed microstructures. At the same total CR reduction of 75%, the TWIP steel exerted intermediate annealing facilitates the formation of twins, endowing the tensile strength vast increase. This would provide a significant reference to improve the mechanical properties of steels via annealing.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
