Effect of Insert Porosity on Combustion Instability in a Lean Premixed Combustor Analyzed by a Proper Orthogonal Decomposition-Based Phase Reconstruction Technique

Abstract

Abstract Lean premixed (LPM) combustion is very effective at mitigating emissions but is vulnerable to strong thermoacoustic instabilities. A porous insert in the shape of an annular ring placed at the dump plane of the combustor has been proven to be an effective passive technique for mitigating these instabilities across a wide range of operating conditions. However, it is unclear if the change results from the insert geometry or porosity of the insert. In this study, swirl-stabilized LPM combustion is investigated for three configurations—without any insert, with a porous insert, and with a geometrically similar solid insert. Acoustics, flow, and heat release rate behavior of the three test geometries are investigated using diagnostics including dynamic pressure and acoustic probes, particle image velocimetry (PIV), and OH* chemiluminescence (OH*CL) imaging. Synchronized measurements at a fixed equivalence ratio were acquired at 40 kHz using sound probes and at 3.5 kHz using PIV and OH*CL. Results include time-series and spectral measurements of pressure, velocity, and OH*CL, and mode analysis by proper orthogonal decomposition (POD). In addition, the dynamics of the instability are investigated by high-resolution phase reconstructions of velocity and OH*CL data using a novel implementation of POD introduced in this work. Results show two different instability modes: a longitudinal instability for the solid insert case and a helical, precessing vortex driven instability for the no insert case. In both cases, the flow field and heat release rate oscillations are coupled to produce the instability. No such coupling or oscillations is observed for the porous insert case. These results ascertain the unique capabilities of the porous insert in protecting against instability from different, simultaneous driving mechanisms and demonstrate that the insert porosity and flow dynamics associated with it are the primary mitigating factors.