Abstract
A biomechanical study using human lumbar spines. To test the hypotheses that with increasing implant height (1) the range of motion (ROM) of the implanted segment will decrease, (2) the segmental lordosis will increase, and (3) the size of the neural foramens will increase. Little is known about the effects of the implant height on the segmental motion and foraminal size at the implanted level. Seven human lumbar spines (age, 54.4+/-11.4 years; L1-sacrum) were tested intact, and after discectomy at L4-L5 and sequential insertion of ProDisc-L implants (Synthes Spine, Paoli, PA) of increasing heights (10, 12, and 14 mm). The specimens were tested in flexion (8 Nm) and extension (-6 Nm) with a 400 N follower preload as well as in lateral bending (+/-6 Nm) and axial rotation (+/-5 Nm) without preload. Three-dimensional motions were measured at L4-L5. Foraminal sizes at L4-L5 were measured in the specimen's neutral posture under a 400 N preload for the intact spine and after each implantation using finely graded cylindrical probes. Segmental lordosis was measured in the specimen's neutral posture under a 400 N preload by analyzing digital fluoroscopic images. Effects of implant height on the kinematics, foraminal size, and segmental lordosis were assessed using paired comparisons with Bonferroni correction. Increasing implant height from 10 mm to 14 mm caused a significant decrease (P<0.05) in segmental ROM by up to 37%+/-21% in flexion/extension, 33%+/-18% in lateral bending, and 29%+/-28% in axial rotation. Increasing implant height also produced a significant increase in segmental lordosis (P<0.05): from 9.7 degrees+/-2.9 degrees at 10 mm, to 16.1 degrees+/-5.1 degrees at 14 mm. The increase in foraminal size, while significant, was only 4.6%+/-3.2% when comparing 10 mm to 14 mm implants. These results suggest that a smaller implant height should be selected to optimize the ROM of the implanted segment and maintain sagittal balance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.