Abstract
The effects of welding hold time on weld quality of aluminium alloy to dual-phase steel resistance spot welds were studied. Results demonstrated that there existed an optimum range of hold time (350∼500 ms), within which the largest weld nugget diameter (7.6 mm), thinnest intermetallic compound (IMC) layer (1∼5 µm) and maximum tensile shear peak load (4.7 kN) were obtained. Too short hold time led to shrinkage, small weld nugget and thick IMC layer due to reduced heat dissipation after removing electrodes, thus resulting in low tensile peak load and brittle fracture along the IMC layer. While too long hold time, i.e. 750 ms, produced a smaller weld nugget diameter due to more rapid heat dissipation.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
