Effect of High-Velocity Oxygen-Fuel Thermal Spraying on the Physical and Mechanical Properties of Type 316 Stainless Steel

Abstract

Data on the microstructural, physical, and mechanical characteristics of high-velocity oxygen-fuel (HVOF)-sprayed type 316 stainless steel coatings are presented and compared with properties of wrought 316 stainless steel. Coatings were prepared at three different spray particle velocities; coating characteristics are presented as a function of velocity. The coatings had relatively low porosity and oxide contents and were significantly harder than annealed, wrought 316 stainless steel. The hardness difference is primarily attributed to high dislocation densities resulting from peening imparted by high-velocity spray particles. The coating hardness increased with increasing spray particle velocity, reflecting increased peening effects. The elastic modulus of the coatings was essentially identical to wrought material. The mean coefficient of thermal expansion of as-sprayed coatings was lower than wrought material, but the expansion of annealed coatings matched the wrought behavior.