Effect of high temperature preoxidation treatment on the oxidation behavior of MoSi2- and WSi2–Al2O3 composites

Abstract

Composites of 30 vol% MoSi2-70 vol% Al2O3 and 30 vol% WSi2-70 vol% Al2O3 were prepared via sintering at 1600 °C in argon. The high-temperature preoxidation treatments were applied at 1000°-1200 °C for 10–120 min in air. The non-isothermal oxidation tests were conducted in air at temperatures ranging between 50° and 870 °C to study and understand the influence of the alumina phase and preoxidation process on the low-temperature oxidation behavior. The optical and scanning electron microscopy, X-ray diffraction, X-ray photoelectron and Raman spectroscopy were used to characterize the surface layers formed. The oxidation-induced mass gains were substantially reduced by 82.1–99.8%, implying their enhanced oxidation resistance. This was due to the formation of highly dense, protective surface layers with a sufficient thickness (3.1–14.2 μm). The structural and surface analyses revealed their complex chemistries, since the ternary (Mo–Si–Al, W–Si–Al) intermetallic, mullite, alumina and silica phases with high oxidation resistances were identified within these surface features. In addition, the high-temperature electrical properties of the composites were highly preserved after the preoxidation treatment, and their electrical conductivities were measured as 45.1–78.6 S/cm at 800 °C and 40.1–69.1 S/cm at 900 °C.