Abstract
Mechanical components in hydrogen energy systems, such as a fuel cell vehicle and related infrastructures, will operate in high-purity hydrogen. Especially, some seals and valves in fuel cell vehicles should articulate against metal counterface within a pressurized hydrogen gas. However, the effect of high-pressure hydrogen gas on tribological behaviour of materials used in sliding surfaces has not been identified yet. In this study, unfilled polytetrafluoroethylene (PTFE) pins and 316L austenitic stainless-steel discs were exposed to high-pressure hydrogen gas and then the chemical and physical changes in their surface and the tribological characteristics were investigated. The results of an X-ray photoelectron spectrometer analysis of the exposed stainless-steel surface indicated that metal oxides in the passive surface layer of stainless steel can be reduced significantly during the high-pressure hydrogen exposure. Increased metal contents of the stainless surface resulted in enhanced metal fluoride formation and subsequent development of a PTFE transfer film. Consequently, the exposed PTFE specimens showed lower specific wear rate when compared to the unexposed specimen.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.