Abstract
The effects of the addition of TaC and hot deformation on the properties of tungsten have been studied. The tungsten and tantalum carbide (W-TaC) alloy was prepared by hot pressing followed by the high-energy-rate forging (HERF) process. The density and Vickers hardness of W-TaC alloy were tested. The microstructure of the composite was characterized by metallographic microscope, scanning electron microscopy, and electron backscattering diffraction (EBSD) imaging. The transient thermal shock resistance of forged W-TaC alloy was also investigated by applying 100 pulses edge-localized mode-like loads in an electron beam facility. The results show that the HERF processing can improve the density and hardness of W-TaC alloy. Preferred orientations of W grains and the subgrain boundaries were observed from the EBSD images. The crack threshold of the developed W-TaC alloys was located between 0.22 and 0.33 GW/m2 at room temperature. When the base temperature increased to 100 °C, no cracks can be observed on the loaded surface at absorbed power density 1 GW/m2.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.