Abstract
Pressure garments are mainly made of elastic Lycra fabrics and tailor‐made to individual patients’ measurements to provide an appropriate amount of skin‐garment interface pressure for burn rehabilitation. However, the fabric tension would be different at various locations from the hem edges of pressure garments, and thus the skin‐garment interface pressure cannot be uniformly maintained over the interface surface. Aims to investigate the pattern of interface pressure changes caused by the different types of edge finish used for making pressure garments. The effect of garment sizes on the change of interface pressure was also examined. Experiments were carried out using two selected elastic Lycra fabrics, four types of hem finish and three different garment sizes. The results of the study provide a guideline for designing the edge finish of pressure garments, and a minimum margin from the hem edges of garments to the scar area is also recommended.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Clothing Science and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
