Abstract
In this work, the evolution of the microstructure, phase composition and crystal structure of 3D products before and after heat treatment, obtained from the original steel 12Cr18Ni10Ti by various metallurgical methods of melting, was studied. The obtained 3D steel samples were subjected to heat treatment, then structural changes were investigated by metallography, X-ray phase (XRD) and X-ray structure (XRD) analyzes. The analysis showed that heat treatment did not increase the grain size of austenite in additive steels, but could lead to an increase in the proportion of ferrite.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
