Abstract
Fe–Cr–C hardfaced coatings are applied over components used in mining, earth moving, ash and coal handling systems. The performance of these coatings depend on microstructural phases present in the deposit post-solidification and/or heat treatment. To prevent the failure of a coating, understanding the mechanical behaviour of the existing phases is one of the key areas of focus. In the current investigation, the study was limited to understand the influence of heat treatment process on nano-scale hardness and reduced modulus properties of phases of Fe–13%Cr–1%C hardfaced alloy coating by accelerated property mapping (XPM) technique. Colour variation in the property maps showed the relative deformation nature of the material. The hardness and reduced modulus values for carbide phases were found to be higher in all conditions. From Weibull statistical analysis, the Weibull modulus values reduced drastically for the carbide phase after heat treatment, revealing higher variability of mechanical properties. The above trends were observed mainly due to %C and %Cr difference across phases and carbide phase morphology transformation happened due to heat treatment.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
