Effect of Heat Treatment on Microstructures and Mechanical Properties of Severe Plastically Deformed Hypo- and Hyper-Eutectoid Steels by Caliber Rolling Process

Abstract

This study investigated the effect of post-heat treatment on the microstructures and mechanical properties of severe plastically deformed hypo- and hyper-eutectoid steels that underwent a caliber rolling process. First, 28 passes of caliber rolling were performed on both the hypo-eutectoid steel with Fe-0.47% C (wt%) composition and the hyper-eutectoid steel with Fe-1.02%C (wt%) composition. Then, the caliber rolled materials underwent heat treatment at 500 degrees C for 1, 3, 5, 10, 30 and 60 minutes. The caliber rolled steel possessed a 300-400 nm-sized oval cementite structure created through elongating and segmentation regardless of the C composition. The observation of heat-treated microstructures showed that cementite structure became globular and ferrite size increased as heat treatment temperature increased. In the hardness measurement, the initial caliber rolled samples showed 372.8 Hv (hypoeutectoid) and 480.1 Hv (hyper-eutectoid). However, hardness dramatically decreased up to 10 min. heat treatments, and then showed a constant or small reduction with time. The yield strengths (compression) of caliber rolled hypo- and hypereutectoid steels obtained were 1097 MPa and 1426 MPa, respectively, and the yield strengths of the same steels after heat treatment (500 degrees C, 60 min.) were identified to be 868 MPa and 1316 MPa, respectively.