Abstract
In order to simulate the hot-dipped galvanizing of dual-phase (DP) steel (wt%) 0.15C–0.1Si–1.7Mn, the DP steels were obtained by different annealing schedules. The effects of soaking temperature, time, and cooling rate on ferrite grain, volume fraction of martensite, and the fine structure of martensite were studied. Results showed that the yield strength (YS) of DP steel is sensitive to annealing schedule, while total elongation has no noticeable dependence on annealing schedule. Increasing soaking temperature from 790 to 850 °C, the YS is the lowest at soaking temperature of 850 °C. Changing CR1 from 6 to 24 °C/s, the YS is the highest when CR1 is 12 °C/s. Increasing soaking time from 30 to 100 s, the YS is the lowest at soaking time of 100 s. Besides, it was found that sufficient movable dislocations within ferrite grains and high martensite volume fraction can eliminate yield point elongation, decrease the YS, and increase ultimate tensile strength. Through TEM observations, it was also found that increasing annealing temperature promotes austenite transformation into twin martensite, and increases volume fraction of martensite at sufficient cooling rate. With increasing the martensite volume fraction, the deformation substructure in the ferrite is well developed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
