Abstract
Compacts prepared from three differently agglomerated powders were studied. Hg‐penetration results and SEM observations were employed to compare the uniformity of powder compacts and to investigate the pore‐size evolution and the microstructural development during sintering. It was found that the more nonuniform the powder compact, the higher the degree of pore growth in the initial and at the beginning of intermediate stages of sintering. Moreover, a higher sintering temperature and a nonuniform microstructure with larger grains could not be avoided. Microstresses might develop because of the differential shrinkage, but they would be released thereafter via the change of grain morphology. It was observed that the aggregate and pore‐boundary separation might not be the primary reason for the initiation of discontinuous grain growth.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.