Effect of gap balancing and measured resection techniques on implant migration and contact kinematics of a cementless total knee arthroplasty

Abstract

BackgroundThe purpose of this study was to compare implant migration and tibiofemoral contact kinematics of a cementless primary total knee arthroplasty (TKA) implanted using either a gap balancing (GB) or measured resection (MR) surgical technique. MethodsThirty-nine patients underwent TKA via a GB (n = 19) or a MR (n = 20) surgical technique. Patients received an identical fixed-bearing, cruciate-retaining cementless implant. Patients underwent a baseline radiostereometric analysis (RSA) exam at two weeks post-operation, with follow-up visits at six weeks, three months, six months, and one year post-operation. Migration including maximum total point motion (MTPM) of the femoral and tibial components was calculated over time. At the one year visit patients also underwent a kinematic exam via RSA. ResultsMean MTPM of the tibial component at one year post-operation was not different (mean difference = 0.09 mm, p = 0.980) between the GB group (0.85 ± 0.37 mm) and the MR group (0.94 ± 0.41 mm). Femoral component MTPM at one year post-operation was also not different (mean difference = 0.27 mm, p = 0.463) between the GB group (0.62 ± 0.34 mm) and the MR group (0.89 ± 0.44 mm). Both groups displayed similar kinematic patterns. ConclusionsThere was no difference in implant migration and kinematics of a single-radius, cruciate retaining cementless TKA performed using a GB or MR surgical technique. The magnitude of migration suggests there is low risk of early loosening. The results provide support for using the cementless implant with either a GB or MR technique.