Abstract

A copper, zinc and aluminium mixed oxides sample having the nominal composition 0.25 CuO/0.03 ZnO/Al2O3 was prepared by impregnating Al(OH)3 with copper and zinc nitrate solutions, drying at 100 °C then heating in air at 600 °C. The obtained solid was exposed to different doses of γ-rays (20–160 Mrad). The surface characteristics namelySBETVP andr of different treated adsorbents were determined from N2 adsorption isothems measured at −196 °C. The catalytic activity of various irradiated solids was determined by following up the kinetics of CO-oxidation by O2 at 150–200 °C. The results showed that the doses up to 80 Mrad resulted in no significant change in theSBET but increased slightly theVP (20%) of the treated adsorbents. The irradiation at 160 Mrad caused an increase of 20% in theSBET of the irradiated solid sample. The catalytic activity increased progressively by increasing the dose, a dose of 160 Mrad brought about an increase of 140% in the catalyst's activity. The apparent activation energy of the catalytic reaction decreased monotonically by increasing the absorbed dose of γ-rays which was attributed to a parallel induced decrease in the value of pre-exponential term of the Arrhenius equation. The observed increase in the catalytic activity due to γ-irradiation has been interpreted as a result of increasing the concentration of catalytically-active sites contributing in chemisorption and catalysis of CO-oxidation via a possible fragmentation of CuO crystallites.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call