Abstract
Fluorine co-implant has been shown to reduce boron transient enhanced diffusion and deactivation when coupled with conventional spike rapid thermal anneals (RTA). For ultrashallow junction formation beyond the 45 nm technology node, non-melt laser spike anneal (LSA) is a promising diffusion-less annealing candidate. In this paper, the effect of fluorine co-implant on boron diffusion during LSA and the subsequent post-LSA thermal budget is evaluated. Silicon wafers were implanted with germanium, fluorine, and subsequently boron ions. Non-melt LSA was carried out at a temperature range from 1150 to 1350°C, followed by RTA at 825°C for 30 s. Secondary ion mass spectrometry confirms that in the presence of fluorine, retarded boron diffusion is observed at LSA temperatures below 1250°C. As the LSA temperature is increased or when a subsequent soak RTA is carried out, enhanced boron diffusion is observed. The reduced boron diffusivity at LSA temperatures below 1250°C is attributed to the efficient capture of interstitials released from the end-of-range defects by fluorine-vacancy clusters during the millisecond anneal. As the thermal budget is increased, excess interstitials caused by the fluorine implant are released, thus increasing the boron diffusion.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.