Abstract
The effect of flow-pattern reconstruction on combustion efficiency and pollutant emission in CFB boilers was investigated with a 1-D CFB combustion model. The results from the 1-D model agree well with the field test data. It was found that, the mass fraction of fine coal particles should be increased at lower bed pressure drop to achieve flow-pattern optimization. As the bed pressure drop decreases, the carbon content decreases first and then increases, both in fly and bottom ash. The change of bed pressure drop is the main factor in the influence of flow-pattern optimization on SO2 emission. The higher the bed pressure drop is, the lower the SO2 emission concentration is. Bed pressure drop and coal size distribution are the chief factors of NOx emission concentration in flow-pattern optimization. With the decrease in bed pressure drop and increase in mass fraction of fine particles, NOx emission concentration decreases first and then increases. SO2 emission concentration can be decreased below 100 mg/m3 by increasing Ca/S, while the original emission concentration of NOx increases. Therefore, other assistant adjustments are also needed to achieve flow pattern optimization, such as the secondary air proportion and CaO particle size distribution.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: DEStech Transactions on Environment, Energy and Earth Sciences
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
