Abstract
A study of the effect of the tool overhang length from the tool holder and cutting forces corresponding to different sizes of the removed layer on the formation of the quality of the surface layer of parts during turning is presented. Linear displacements arising in a stress-strain state and roughness parameters were used as estimated parameters. It is revealed that the quality of the surface layer improves with a decrease in vibration in the zone of contact between the workpiece and the tool.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
