Abstract
Abstract Limitation in practical applications of biopolymer–fiber composite is mainly at higher temperatures. Thus, this study highlights the effects of fiber orientation on the durability of polylactic acid (PLA) reinforced with unidirectional (UD) continuous kenaf fibers at elevated temperatures. PLA and long kenaf fiber were fabricated using the hot-pressing method and stacked at fiber orientations of 0°, 45°, or 90°, relative to the tensile force. Dynamic mechanical analysis of the composites shows excellent anti-shock and temperature-resistant properties of the composite. UD PLA–kenaf composites with a 0° fiber orientation showed an ultimate tensile of ∼190 MPa and a flexural strength of ∼235 MPa, and the strength of the composite was able to retain up to 120°C temperature. The debonding behavior of the fiber from the matrix (fiber pull-out) supported by microscopy proved that interfacial failure occurs from the local strains, which initiate cracking. Interfacial failure and stress transfer have caused a remarkable reduction in composite strength when fibers were oriented at 90°. Hence, this current improvement in the performance of the UD PLA–kenaf fiber composite may potentially replace conventional synthetic fibers, especially for structural automotive applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.