Abstract
Increased demand on the mechanical and thermal properties on the thermal interface and die attach material creates a demand for materials with tailored material properties. Solder matrix fiber composites (SMFCs) have been shown to address these challenges, but have, so far, required complicated procedures and components. In this paper, we present the fabrication of a new type of SMFC based on commercially available fiber networks infiltrated with Sn–Ag–Cu alloy (SAC305) or indium using equipment for large-volume production. The composite material exhibits similar thermal properties compared to pure solder, and mechanical properties that can be tailored toward specific applications. We also show that the handling properties of the SMFC allows it to be used in process flows where multiple reflow cycles are required and can achieve a well-defined bond line thickness (BLT) and good bonding using fluxless reflow under pressure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Transactions on Components, Packaging and Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.