Abstract
Non-deformable inclusions are detrimental to the surface quality and mechanical properties of stainless-steel plates. Plant trials were conducted to investigate the effect of different ferrosilicon alloys and calcium treatment during argon oxygen decarburization (AOD) and ladle furnace (LF) refining on inclusions in Si-killed 304 stainless steel. The inclusions were examined by scanning electron microscope with energy dispersive spectrometer. The results show that both the contents of soluble aluminum in molten steel and Al2O3 in slag increase with the increase of aluminum content in FeSi alloy. The content of soluble aluminum in liquid steel could be limited to lower than 0.004% when using ultra-purity FeSi alloy. When the calcium wire addition is 2 m/t, inclusions are located in the low-melting-temperature region, and the inclusion rating of hot rolled plates is mainly C-class. Industrial application shows that, by decreasing the soluble aluminum content in liquid steel, decreasing the MgO and Al2O3 in slag in AOD, and applying low basicity refining slag as well as calcium treatment, the inclusions are low melting point silicates. The inclusion rating of hot rolled plates is mainly fine C-type with a small amount of class-A, and surface polishing qualification rate is increased from 17.8% to more than 88.7%.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
