Abstract
The purpose of this research is to investigate the effects of microstructural parameters as a result of three different processing methods on the deformation and fracture properties of SiC/Al composites. The influences of heat treatment are also investigated. It was found that without heat treatment, the SiC reinforcement phase significantly improved the strength of the composite compared to the Al matrix material. However, the strengths of the heat-treated composites were roughly in the same range as those of heat-treated Al alloy. The ball-milled composite has higher strength, but lower fracture toughness compared to the powder and flake composites. Between the latter two, the powder composite has higher toughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
