Effect of Eutectic Si Particle Morphology on ECAP Formability and Mechanical Properties of AC4CH Aluminum Casting Alloys

Abstract

AC4CH casting alloys were subjected to the 2-step preheating and the ECAP processing at room temperature. Microstructure change was investigated in terms of size and globularity of the eutectic Si particles and hardness of the primary and the eutectic� -Al. The effects of 2-step preheating, ECAP processing and standard T6 heat treatment on the hardness and the tensile properties were also investigated. The results of this study are as follows. The ECAP formability was significantly improved by the optimum 2-step preheating (1st-step preheating at 560 � C and 2ndstep preheating at 350 � C). More than 12-times ECAP pressing (equivalent strain of about 5.6) could be made without cracking. The hardness distribution in the primary � -Al suggested that the accumulated plastic strain during the ECAP processing increased gradually toward the eutectic cell regions. The hardness measurement also showed that the accumulated plastic strain of the eutectic � -Al around less-globular Si particles was higher than that around globular Si particles. Concentration of the plastic strain may promote cracking in the eutectic cell regions and deteriorate the ECAP formability. Successive processing by the 2-step preheating, the ECAP processing and the standard T6 heat treatment brought about globularity and homogeneous distribution of the eutectic Si particles. During the tensile deformation, these microstructural features might lead to homogeneous distribution of the plastic strain, suppressions of the cracking of Si particles and the delamination between the Si particle and the matrix. As a result, the 0.2% proof stress and the fracture strain increased about 11% and 47% respectively compared with those of the standard T6 treated sample. [doi:10.2320/matertrans.L-M2011822]