Abstract

A series of Al-40Zn-5Si alloys with different additions of Eu were prepared by permanent mold casting. The nucleation phenomenon incorporating the modification of silicon phase was investigated by using the synchrotron radiation imaging technology, scanning electron microscopy, electron probe microanalysis and high resolution high-angle annular dark-field scanning transmission electron microscopy. It was found that the primary phase was α-Al dendrites and the pre-eutectic Si particles were precipitated continuously at the front of the solid/liquid interface in Al-40Zn-5Si alloys. The nodular pre-eutectic Si particles were observed when the Eu addition was 0.3%. Meanwhile, a flake-to-fibrous transition of eutectic Si was also observed. The needle-like eutectic Si crystals were seen to shoot out from the vicinity of primary α-Al dendrites into melt with high velocities leading the irregular eutectic interface in the unmodified Al-40Zn-5Si alloy. However, the eutectic grains with smooth interfaces nucleated mainly near primary or secondary α-Al branches in 0.3% Eu-modified Al-40Zn-5Si alloy. The eutectic grains began to nucleate on the nodular pre-eutectic Si particles when the α-Al surface reached so close to them. The formation of nodular pre-eutectic Si particles was attributed to the adsorption of Eu atoms along the <112> growth direction of Si and at the intersection of Si twins. This is fully consistent with the well-known poisoning of twin plane re-entrant edge (TPRE) and the impurity induced twinning (IIT) modification mechanisms proposed for interpreting the modification of eutectic Si.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call