Abstract

Objective: To evaluate in vitro the effect of the erbium, chromium:yttrium-scandium-gallium-garnet (Er,Cr:YSGG) laser on resistance of primary and permanent human enamel to demineralization using water cooling and fluoride coapplication as variable parameters. Methods: Enamel specimens were prepared from extracted primary and permanent teeth (n = 225 each). The specimens were separated into 15 subgroups (n = 15/group) based on laser application at three different power settings (0.25, 0.50, and 0.75 W), laser application with and without water cooling, and application of acidulated phosphate fluoride (APF) gel before laser treatment. Morphological changes were assessed with scanning electron microscopy (SEM), and the specimens' chemical contents were determined with energy-dispersive X-ray spectroscopy. Results: In both the primary and permanent teeth, the highest Ca and P content was observed in the noncooled 0.75 W laser group (p < 0.05), irrespective of APF pretreatment (p > 0.05). The Ca and P content for the noncooled APF +0.75 W laser group was lower than that for the APF group and the noncooled 0.75 W laser group. For both dentitions, the F mass content for the APF+laser groups was significantly higher than laser-only groups (p < 0.05). Under SEM, both the primary and permanent enamel exhibited cracks, craters, and surface roughness without water cooling, consistent with increased power output. Conclusions: Er,Cr:YSGG laser application at 0.75 W without water cooling increased enamel resistance to demineralization. Compared with topical APF application, Er,Cr:YSGG laser application barely improved enamel resistance against demineralization, and coapplication did not result in a synergistic effect.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call