Abstract
The presently predicted total heating power of the demonstration fusion reactor DEMO is ∼3 times the ITER value, while the major radius is only 1.5 times larger (R. Wenninger, et al., The DEMO Wall Load Challenge, Nucl. Fusion 57 (2017) 046002 (11pp)) [1]. The current DEMO technological wall heat load removal capability is limited to ∼1MW/m2, due to structural material limitations and the tritium breeding requirements, while the ITER first wall (FW) is designed for values up to 4.7MW/m2. This paper focuses on the evaluation of the effect of the engineering constraints on the required limitation of charged particle heat load.First, a 2D field-mapping tool is used together with a simple model to take into account the peaking factors present on an engineering 3D wall design. A sensitivity analysis is performed on a set of realistic FW 3D features considering a preliminary estimate of misalignments. The impact on the heat flux to the wall due to different machine geometries, plasma shapes variation, stationary plasma and plasma transients, is presented. An automatic procedure to define the 2D poloidal contour of the FW for minimized particle loads is presented. A subset of the resulting engineering wall design is analyzed using the 3D field line tracing code PFCflux.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
