Abstract
ABSTRACT Flash sintering (FS) is becoming a popular densification route for high-temperature oxide ceramics because of its rapid sintering performance. In the current study, bar-shaped hydroxyapatite (HA) specimens were hung between two Pt wire electrodes and consolidated by FS through a direct electric field at a constant furnace temperature (1000°C or 1100°C) in air. The electric field facilitated the sintering of HA at relatively lower furnace temperatures than that obtained using the conventional sintering method. The voltage required for the onset of the flash decreased with increasing furnace temperature. The effects of the DC electric field strength at different sintering furnace temperatures were examined in terms of the phase evolution and stability of HA. HA phase dissociation was not observed regardless of the electric field strength or furnace temperature because of the very short FS time. Higher grain growth with fast densification in the flashed-sintered HA samples occurred with increasing electric field strength at each furnace temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.