Abstract
This in vitro investigation examined pre- and postinstrumentation working length (WL) measurements in curved root canals. The conditions compared were combinations of (a) stainless steel hand files + Gates Glidden drills (SS) versus nickel-titanium rotary files (Ni-Ti); and (b) early coronal flaring (flaring completed before WL determination) versus late coronal flaring (flaring completed after WL determination). Coronal flaring was accomplished for the SS group using Gates Glidden drills and for the Ni-Ti group using rotary Ni-Ti files (n = 15/group). WL was determined before coronal flaring, immediately after coronal flaring, and again after canal preparation. Results indicated that WL decreased for all canals as a result of canal preparation. The mean decrease in WL was significantly greater for the SS group (-0.48 mm +/- 0.32) than for the Ni-Ti group (-0.22 mm +/- 0.26). Less change in WL occurred in both groups when initial WL was determined after coronal flaring (SS: -0.12 mm +/- 0.13, Ni-Ti: -0.14 mm +/- 0.25).
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
