Abstract
Single-bead, laser-deposited Inconel® 718 tracks atop substrates of the same composition were studied to ascertain the influence of laser power, processing speed, working distance, and substrate preheat on the fusion zone geometry, microstructure, and hardness. Modifying working distance encompassed both a change in powder flow distribution and beam diameter. Laser power and processing speed linearly affected fusion zone width and area, though laser power was found to have the most significant effect of all processing parameters. Preheating the substrates increased the width of the fusion zone by an average of 16% and led to a more uniform hardness throughout. The fusion zone cross-section was found to morph from semicircular to double-parabolic (wavy) with increasing laser power. This was attributed to surface tension induced Marangoni flow and the influence of surface-activated species on surface tension. The applicability of coupled parameters, including linear heat input and normalized enthalpy were investigated. Given the limited data available on the influence of processing parameters, particularly working distance and substrate temperature, on fusion zone geometry and hardness, results reported here may aid experimentalists and modelers working on cladding and additive manufacturing processes.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
