Effect of diblock copolymers on dynamic mechanical properties of polyethylene/polystyrene blends

Abstract

AbstractA systematic investigation of the dynamic mechanical properties of high‐density polyethylene (HDPE)/high‐impact polystyrene (HIPS)/copolymer blends was carried out. Blends of 80/20 weight percent of HDPE/HIPS were prepared in the melt state at 180°C in a batch mixer. Synthesized pure diblock (H77) and tapered diblock (H35) copolymers of hydrogenated polybutadiene (HPB) and polystyrene (PS) were added at different concentrations (1, 3, and 5 wt %), and the dynamic mechanical properties were investigated. The results show that: (1) both the tapered and the pure diblock copolymers enhance the phase dispersion and the interphase interactions; (2) structure and molecular weight are both important parameters in the molecular design of copolymers; (3) important effects occur when only small amounts of copolymer are added (up to the interface saturation concentration SC); (4) a micellar structure formation is possible when the copolymer is in excess in the blend; (5) the effect of the copolymer structure on the SC and the critical micellar concentration (CMC) is more pronounced than the effect of molecular weight. These concentrations are found to be lower for the tapered diblock copolymer. The analysis of the dynamic mechanical thermal analysis (DMTA) results obtained for the 20/80 HDPE/HIPS blend leads to the conclusion that the copolymers also enhance the interactions between heterogeneous phases. Similar conclusions based on electron microscopy were reported in the literature. DMTA shows great potential to relate macroscopic observations to the state of a copolymer in an immiscible blend.