Abstract
The mechanical properties and microstructures were investigated for AZ80 Mg alloy during plane strain compression and extrusion processing. The results show the tensile strength increases with the increasing deformation degree in the two-phase zone due to sufficient dynamic recrystallization and work-hardening effect. In single-phase zone, the tensile strength increases firstly and then does not varies basically when the deformation degree is greater than a certain critical value. This is very beneficial to optimize processing parameters to obtain microstructure with improved mechanical behavior.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
