Effect of cutting edge radius on end milling Ti–6Al–4V under minimum quantity cooling lubrication – Chip morphology and surface integrity study

Abstract

The effect of cutting edge radius (30–55 μm) during milling Ti–6Al–4V under minimum quantity cooling lubrication (MQCL) conditions is studied. A trial study is conducted to compare the performance of dry, wet, and MQCL using unprepared tools with edge radius of 30 μm alone. Subsequently, inserts having initial radius of 30 μm are prepared to 40–55 μm radius using drag finishing and milling of Ti–6Al–4V under MQCL is studied for different edge radii. Rounded edge tools are found to produce thinner and more curvilinear chips resulting in easier chip removal from the machining zone. The chip thickness and curl radius were up to 54% and 47% lower for the larger edge radius tools as compared to the 30 μm edge radius tool. This improves the penetration of the MQCL aerosol jet into the cutting zone thus producing better tribological results. The better penetration of MQCL aerosol into the cutting zone for larger edge radius tools results in lowering the resultant process forces (up to 16%), tool-chip interface temperature (15%), tool wear (40%) and surface roughness (30%) for the 48 μm radius tool as compared to the unprepared (30 μm) tool. There is deterioration in process forces, tool wear and surface integrity for the 55 μm tool possibly suggesting the existence of an optimum edge radius closer to 48 μm.