Effect of Curvature Location on Fatigue Resistance of Five Nickel-titanium Files Determined at Body Temperature

Abstract

IntroductionThe purpose of this study was to evaluate the effect of 5 different curvature locations on the fatigue resistance of thermomechanically treated nickel-titanium (NiTi) files and superelastic NiTi files at body temperature and to document the corresponding phase transformations. MethodsEndoSequence (ES; Brasseler USA, Savannah, GA), EndoSequence CM (ESCM, Brasseler USA), K3 (SybronEndo, Orange, CA), K3XF (SybronEndo), and Vortex Blue (VB; Dentsply Tulsa Dental Specialties, Tulsa, OK) NiTi files (size 25/.04) were subjected to fatigue tests inside customized artificial canals containing a curvature of 60° and a 3-mm radius. There were 5 different canals based on the location of initial curvature; these included groups in which the distance between the canal orifice and the location of the curvature (DOC) was 5, 6, 8, 10, and 11 mm. The model canal was immersed in water at 37°C ± 1°C. The number of cycles to failure (Nf) was recorded, and the fracture surface of the fragments was examined by scanning electron microscopy. Two unused files of each brand were examined by differential scanning calorimetry. ResultsThe Nf was highest in the 10-mm and 11-mm DOC groups and lowest with the 5-mm and 6-mm DOC groups (P < .05). ESCM files had the highest fatigue resistance followed by the VB, K3XF, K3, and ES files (P < .05). ESCM files had the highest Nf (P < .05), and ES and K3 files had the lowest Nf (P < .05) depending on the curvature location. Two endothermic peaks were observed on the heating curve of the heat-treated files (ESCM, K3XF, and VB). ConclusionsThe location of the canal curvature had a significant effect on the fatigue resistance of both heat-treated and superelastic NiTi files. The fatigue life of files in the coronal curve was quite short.