Effect of crumb rubber characteristics on crumb rubber modified (CRM) binder viscosity

Abstract

Asphalt binder viscosity is of great importance during the production process of hot mix asphalt mixture as typically asphalt plants will store binders between 149 °C and 177 °C. SHRP guidelines state that asphalt binder viscosity must not exceed 3 Pa s. Therefore, given the documented increases in asphalt viscosity when modified with crumb rubber modifier (CRM) it is necessary to produce asphalt binder that fulfills the SHRP criteria while not exceeding plant mixing and storing requirements. This paper reports the results of an investigation of the importance of CRM properties on viscosity of CRM binder. Two binder sources were modified at four concentration levels using four different crumb rubber sources; the viscosities of the produced binders were evaluated by AASHTO T 316. Crumb rubber properties were evaluated by elemental analysis using a scanning electron microscope (SEM) and by determination of glass transition temperature ( T g) using a differential scanning calorimeter (DSC). In general, results indicate that processing procedure and tire type plays an important role in the determination of CRM binder viscosity.