Effect of condylar rotation on the stress environment of the temporomandibular joint in patients with mandibular protrusion

Abstract

Purpose: The study aims to analyse the effects of condylar rotation on the biomechanical environment of the TMJ after bilateral sagittal split ramus osteotomy (BSSRO) through the finite element method (FEM). Methods: Thirteen patients with mandibular prognathism and twenty-three normal subjects were recruited. The three-dimensional (3D) models were reconstructed. 13 representative morphological parameters were measured for comparison. A patient was selected to perform virtual BSSRO surgery by rotating the condyles in MIMICS. The preoperative and postoperative 3D models of the patient were subsequently imported into ABAQUS for finite element analysis. The preoperative and postoperative stresses and joint spaces in the TMJs were investigated. Results: The maxillofacial morphologies of the patients with mandibular protrusion was significantly different from those of the asymptomatic subjects (P<.05). Stresses in the postoperative group were lower than those in the preoperative group. The rotation of the condyle could cause the variations in stress levels and joint spaces within the TMJs. Inward and upward rotation of the condyle was associated with higher stress in the TMJ, whereas the lowest stress was observed when the condyle remained stationary following surgical intervention. Significance: Lateral, medial and superior joint spaces were more related to the stresses in the TMJs. The condyle should be kept in place as much as possible to avoid disrupting the balance of the TMJ in patients with mandibular protrusion.