Abstract

This study examines the primary and ultimate biodegradation of a non-ionic surfactant, an alkylpolyglucoside, in ready biodegradability tests. The surfactant concentration was tested by the anthrone method, while the ultimate biodegradation (mineralization) was analyzed by the total organic carbon determinations. The influence of the concentration on the extent of primary and ultimate biodegradation and the kinetics of degradation also were determined. The primary and ultimate biodegradation was studied at different initial concentrations-15, 25, 50, 75, and 100 mg/L. The increasing concentration of test chemical from 15 to 100 mg/L resulted in a decrease in the relative maximum mineralization rate and longer estimated lag times by a factor of approximately 4.3. During the degradative process, two different stages were noted; these are better described with Quiroga and first-order kinetic models, respectively. For the study of the influence of concentration, the parameters characteristic of the biodegradation profiles in the different biodegradation assays were evaluated.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.