Abstract
Abstract Al-18%Pb and Al-22%Pb alloys processed through the spray deposition technique to obtain the homogeneous distribution of the Pb paricles into the aluminum grains, where as in case of conventional methods Pb paricles not distributed homogeneously . Optimum uniformity obtained at the pressure 10bar , spray deposition distance about 430mm and rotor inclination angle about 00. The spray deposits cold rolled for various percentage thickness reductions , porosity , hardness and wear properties were studied . the porosity of the sprayed deposits lower than the conventional one in comparison . the mechanical properties of the spray deposited alloys shows increment than the cast alloys . the wear resistance of spray deposited Al-18%Pb is showed better than the Al-22%Pb alloy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
