Abstract
Microcantilevers with polymer coatings hold great promise as resonant chemical sensors. It is known that the sensitivity of the coated cantilever increases with coating thickness; however, increasing this thickness also results in an increase of the frequency noise due to a decrease of the quality factor. By taking into account only the losses associated with the silicon beam and the surrounding medium, the decrease of the quality factor cannot be explained. In this paper, an analytical expression is obtained for the quality factor, which accounts for viscoelastic losses in the coating. This expression explains the observed decrease of the quality factor with increasing polymer thickness. This result is then used to demonstrate that an optimum coating thickness exists that will maximize the signal-to-noise ratio and, thus, minimize the sensor limit of detection
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.