Year-end Sale % OFF 
Abstract
AbstractThe shrinkage of unsaturated polyester (UP)/styrene (St) resins cured at low temperatures can be reduced by the presence of low‐profile additives (LPAs). It is believed that the reaction‐induced phase separation and the polymerization shrinkage in both the LPA‐rich and UP‐rich phases result in the formation of microvoids, which partially compensates the resin shrinkage. The relative reaction rate in the two phases plays an important role in shrinkage control. In this study, secondary monomers [such as divinylbenzene (DVB) and trimethylopropane trimethacrylate (TMPTMA)] and a co‐promoter, 2,4‐pentandione (2,4‐P), were added into the UP/St/LPA resin systems to investigate their effect on the shrinkage control of resins cured at low temperatures. Dilatometery results showed that the addition of both TMPTMA and 2,4‐P resulted in an earlier volume expansion during curing and better shrinkage control. The phase separation, reaction kinetics, and viscosity changes in the LPA‐rich and UP‐rich phases during curing were also investigated. The results confirmed that the increased reaction rate in the LPA‐rich phase led to an earlier formation of microvoids and, consequently, less volume shrinkage of the cured resin. © 2001 John Wiley & Sons, Inc. J Appl Polym Sci 82: 738–749, 2001
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
