Abstract
The present investigation shows the role of chromium in Fe–P binary and Fe–P–Cr ternary alloys. The compositions are characterized in terms of microstructure, porosity content, hardness and tensile properties. The alloys were made using a hot powder forging technique. In this process mild steel encapsulated powders were hot forged into slabs. Then the slabs were hot rolled and annealed to relieve the residual stresses. Densifications as high as 98.9% of theoretical density have been realized. Microstructures of these alloys consist of single-phase ferrite only. Both Fe–0.45P and Fe–0.45P–3Cr alloys showed very high strength. As forged and hot rolled Fe–0.45P alloy showed low elongation. It was observed that, the addition of Cr to Fe–P based alloys caused an increase in strength associated with the reduction in ductility. Alloys developed in the present investigation were capable of hot working to very thin gage of sheets and wires.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
