Abstract
Here we investigate the effect of chemistry, including initial powder chemistry and spatial chemical variations due to vaporization during fabrication, on strain-induced martensitic phase transformation in 304L stainless steel components fabricated by directed energy deposition (DED) additive manufacturing (AM). The austenite stability was altered by mixing pre-alloyed 304L stainless steel powder with Fe powder, which promoted martensitic phase transformation and resulted in an increase in ultimate tensile strength and elongation to failure over pure 304L walls deposited by DED AM. The chemical composition variation with position, due to spatial variations in thermal history, was quantified, showing that austenite stabilizing elements Cr, Mn, and Ni were preferentially vaporized during deposition. We present a martensitic transformation kinetics equation that describes the evolution of martensite volume fraction with respect to plastic strain as a function of chemistry. This allows for the prediction of strain-induced martensite evolution as a function of strain, nominal chemistry, and heterogeneous chemistry due to vaporization within additively manufactured components.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
