Abstract
CrFe2NiMnV0.25C0.075 and CrFe2NiMnV0.25C0.125 high-entropy alloys (HEA) were processed by high-pressure torsion (HPT) followed by post-deformation annealing (PDA) at 823 and 1273 K. This severe plastic deformation led to a significant microhardness increment (by a factor of ~ 2.5) up to ~ 435 Hv and the microstructures exhibited exceptional grain refinement with average grain sizes of ~ 30 nm in both HEAs. It was found that the hardness increased up to ~ 555 Hv after annealing at 823 K due to precipitation of the σ phase, but thereafter the hardness decreased to ~ 195 Hv after annealing at 1273 K which was very close to the value of the initial coarse-grained condition. This behavior is caused by a combination of grain coarsening and a dissolution of the precipitates. These results suggest that the nanocrystalline HEA facilitates the formation of precipitates owing to the large number of grain boundaries which serve both as fast diffusion pathways and as preferential nucleation sites for precipitate formation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.