Abstract
The effects of carbon black and pyrogeneous silica fillers on the interfacial properties of a homopolymer [polybutadiene, (PB)] and a terpolymer [brominated poly(isobutylene-co-p-methylstyrene), (BIMS)] are reported. Neutron reflectivity (NR) was used to study the interfacial structure. The results are complemented by scanning transmission X-ray microscopy (STXM) and lateral force microscopy (LFM), which were used to probe the morphology and surface lateral force. Small-angle neutron scattering (SANS) was used to characterize the size and surface properties of the filler aggregates in elastomers. Our results show that the interfacial behavior of PB/BIMS is more sensitive to carbon black than to silica. The interfacial broadening is significantly slowed down with addition of merely φCB = 0.01 (volume fraction) carbon black fillers. This volume level is much lower than that used in bulk rubbers (φCB ≥ 0.1). Pyrogeneous silica has a less pronounced effect on the interfacial characteristics. When both carbon and silica are incorporated into the PB layer, the effect of carbon black is offset by silica fillers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
