Abstract
When the tool leaves the part during machining operations, burrs can form as a result of material plastic flow. Wire brushing is one of burr removing methods. Low cost of brushes which can be mounted in a milling center gives the perspective of developing this method. The article was aimed at presenting the results of brushing process upon edge radius after wire brushing of AZ91HP magnesium alloy. Three kinds of brushes were tested with different types of fibers and the diameter of a single fiber. Brass and steel brushes were used.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Advances in Science and Technology – Research Journal
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
