Effect of brushing force on the abrasive dentin wear using slurries with different abrasivity values.

Abstract

The aim of this study was to investigate the resulting abrasive dentin wear using abrasive slurries with different RDA values and applying increasing brushing forces. Forty-five bovine incisors were randomly allocated in three groups (A, B, C, n= 15). One hundred and eighty dentin samples were prepared from these incisors and allocated to twelve groups (A1-A4, B1-B4, C1-C4; n= 15). The groups were subjected to a brushing cycle (120 strokes/min, 25 min) as follows: groups A1 to A4 with an abrasive slurry (RDA=71) applying increasing brushing forces (1, 2, 3 and 4N). Groups B1 to B4 were brushed using an abrasive slurry (RDA=85) and C1 to C4 (RDA=133) applying the same above-mentioned brushing forces. Abrasive dentin wear was recorded using a stylus profilometer and compared amongst the groups using robust models. Pairwise comparisons in each model were tested and corrected after Tukey's method (α= 0.05). Applying 1-N brushing force resulted in the same amount of abrasive dentin wear in all groups regardless of the abrasivity of the used slurry. Increasing the brushing force to 2N resulted in statistically significantly higher abrasive wear in all groups. This increase in abrasive wear was much higher when the slurry with high abrasivity was used (RDA=133) compared with the lower abrasive slurry (RDA=71). The abrasivity of the used slurry does not add to the resulting abrasive wear when the brushing force is kept at 1N. It seems better to advise and help the patients (showing signs of non-carious cervical lesions) calibrating their brushing force to 1N, than only to advise them to use toothpastes with lower abrasivities.