Abstract
Abstract We have investigated the influence of blood flow on thrombin generation, fibrin formation, and fibrin deposition on procoagulant and nonprocoagulant surfaces. Nonanticoagulated human blood was drawn for 5 minutes directly from an antecubital vein over stimulated endothelial cells expressing tissue factor and over human type III collagen fibrils, positioned in parallel-plate perfusion chambers. The shear rates at these surfaces were 50, 650, and 2,600 s-1. Deposition of platelets and fibrin was measured by morphometry. Thrombin and fibrin formation was determined by measuring prothrombin fragments 1 + 2 (F 1 + 2), thrombin-antithrombin III complexes, (T-AT) and fibrinopeptide A (FPA) in blood effluent from the perfusion chamber at the end of the 5- minute perfusion period. On procoagulant endothelial cells, the thrombi were primarily composed of fibrin. The fibrin deposition (81%, 21%, and 2% at 50, 650, and 2,600 s-1, respectively) and plasma levels of F 1 + 2, T-AT and FPA were shear rate dependent and highest at 50 s-1. There was a positive correlation between F 1 + 2 and T-AT and the fibrin deposition (P < .01). In contrast, the collagen surface triggered primarily thrombi that were composed of platelets. The platelet thrombi and plasma levels of F 1 + 2 and T-AT were also dependent on the shear rate, but highest at 650 and 2,600 s-1. F 1 + 2 and T-AT reached the same level as observed with procoagulant endothelial cells at the higher shear rates. There was a positive correlation between F 1 + 2 and T-AT and the platelet thrombus formation (P < .05), confirming the predominant role of platelets in thrombin generation. Thus, thrombin formation is strongly influenced by the blood flow, and this effect depends on the composition of the thrombogenic surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have