Abstract
traconazole (ITZ) polyethylene glycol 4000 (PEG) solid dispersions (SDs) containing hydroxypropyl methylcellulose (HPMC) and/or low methoxy pectin (LMP) were prepared by melting method at a ratio of drug to carrier of 1:9. ITZPEG formulations showed the highest drug release (83.51%) when compared to the formulations containing HPMC and/or pectin (i.e., 43.02%, 40.64% and 59.94% for those containing HPMC, LMP and HPMC+LMP, respectively). Powder X-ray diffractograms of all formulations revealed that the drug was present in an amorphous form while a crystalline form was observed only in ITZ or its physical mixture. After storage at accelerated condition (40°C, 75%RH) for 2 and 12 months, the crystalline of ITZ was clearly not observed in all SDs. All formulations showed an increase in mean dissolution time (MDT) but the formulations containing biopolymer showed the lower MDT than that containing no biopolymer. The results suggested that either HPMC or LMP in SDs can help to inhibit the recrystallization of amorphous ITZ in SD, probably by a polymer anti-plasticizing effect.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.